thermal equivalent
英 [ˈθɜːml ɪˈkwɪvələnt]
美 [ˈθɜːrml ɪˈkwɪvələnt]
网络 食物的热价; 热价; 热当量
双语例句
- Although the actions of the residual compressive strains and the residual contractive thermal strains are equivalent for causing the welding residual stress, it is useful distinguishing them to develop new measures relieving and adjusting the welding residual stress in practical joints.
虽然残余压缩应变和残余收缩应变在导致焊接残余应力产生的作用方面是等价的，但其机理却有本质的不同，区别二者有利于研究和开发新的焊接残余应力调控技术。 - Then, a theoretical model of the heat transfer in the composites is established based on the laws of the minimal thermal resistance and the specific equivalent thermal conductivity.
基于最小热阻力法则和比等效导热系数相等法则，建立了热量传递的理论模型，并推导出了等效导热系数的计算式。 - The most convenient way of studying the thermal effect is using an ideal lens with equivalent thermal focal length.
研究激光工作物质内热效应的最方便的方法是等效热透镜（TL）法。 - Thermal distortion analysis for conduction cooled end-pumped slab THE EQUIVALENT STEP PLANAR WAVE-GUIDE METHOD FOR DIFFUSED PLANAR WAVE-GUIDE
传导冷却端面泵浦板条放大器波前畸变数值研究扩散平板光波导的等效阶跃平板波导方法 - Whatever shapes of solder joints, under the thermal loading, the distribution of the largest equivalent Von Mises stress/ strain are all approximately same which is in the brim of solder close to the joint of solder and PCB.
研究发现，在热载荷作用下，鼓形、凹形及柱形钎料焊点的最大应力应变分布大致相同，均在钎料球的外边缘。 - Using the Thermal-Structure integrative analysis method, it can figure out thermal loads of equivalent node resulted from the temperature of truss pole element which is the primary structure of the deployable antenna, and it also construct the relevant finite element equation of thermal elasticity.
采用热结构一体化的分析方法，计算出组成可展开天线主要结构桁架杆单元由于温度引起的等效结点热载荷，并建立了相应的热弹性有限元方程。 - Exacting the transient thermal impedance can help to set up the thermal characteristic equivalent network.
瞬态热阻抗的提取有助于系统热特性等效网络的建立。 - With the model of a thermal thin lens, we give an equivalent linear cavity to analyst its beam characteristics.
本文采用热薄透镜模型，运用等效腔方法，分析了四镜环形腔的光束特性。 - Based on the liquid film theory of hot crack formation and results of numerical simulation of solidification and thermal strains, equivalent strain is proposed to serve as the criterion for hot cracking.
从热裂产生的液膜理论出发，根据凝固过程温度场和应力场、应变场的数值模拟结果，提出了热裂形成的等效应变判据； - By analogy, the thermal effect is replaced by an equivalent edge-moment loaded uniformly along both boundaries of the shallow spherical shell.
再通过比拟，以作用于球面扁壳内外边界上的均匀分布的相当边界力矩来替换温度效应。